When I was getting the Debatable Lands Woodworking Guild started, I polled the people who were attending planning meetings to see what projects we could work on as a group to produce things for the Barony. One of the ideas was to produce “portable desk” type scribal boxes that the Baron and Baroness could gift to scribes. It’s taken me some time to get around to it, but I was finally able to plan out what such a thing might look like, and use up some surplus wood from the garage to make a prototype.
This simple, hinged-lid box is made entirely from pine, and finished with amber shellac. The walls of the box are half-inch thick, and the larger surfaces are 3/8″ thick. both thicknesses are the result of planing down some 3/4″ lumber to remove severe cupping warpage. The top and bottom were made from some 1×12 shelving, so I was able to make the full width of the box from a single piece without resorting to plywood.
The work surface is 11 inches wide and about 12.75″ tall, a fine size to accommodate 8.5″x11″ or 9″x12″ paper with some room to spare. A slight slope should make work a little easier on the wrists.
I have no historical examples for this kind of box, I am merely imitating other scribal boxes I have seen in use around the SCA.
The interior of the box is about 10 inches by 14 inches, able to hold supplies slightly larger than average to a depth of about 1 inch at the front and 3 inches at the back. It’s slightly less than that because I decided to add the two battens underneath the lid to support the thin wood during use and keep it from warping.
The box is assembled using modern wood glue and wire nails, and finished with three coats of amber shellac. I’m not sure why my shellac came out so streaky this time. It could be that the shellac needs more alcohol in the mix, or that it was very hot in the shop yesterday causing the finish to dry more quickly than it could even out.
Because I had suitable material on hand, shaping and assembly of the box took less than a day. I did some hand sawing, but a lot of the sawing was done on the band saw. Assembly was entirely by hand, even to the level of hammering in the nails by hand to avoid blowing out the thin wood sides with the nail gun.
