According to the takadai book that I have, the used takadai that I bought from a friend needs one more accessory to be complete. The raddle is used during set-up to keep the strands separated and in order before they are wound onto tama and placed on the koma. This takadai may not even have come with a raddle, since it is not 100% necessary for braiding. Having set up for two braids now, I can confirm it is optional. It does seem handy to have, though, so I decided to make one.
Takadai with Raddle
Thw raddle is the bar across the front of the takadai that is basically a row of pegs. I bought a piece of maple, and cut it down to the size I wanted. Then I drilled a line of 3/16″ holes along the length of the bar using the drill press, and rounded the top and side edges with a router.
Next, I cut a few 3/16″ diameter dowels into 1″ lengths. I rounded the ends of each peg with a Dremel grinding stone, and then glued one peg in each hole.
After attaching a couple of small blocks to the underside of the raddle so that it can be mounted in the slots of the outer arms, the raddle was ready to go.
When I was in Japan for the TV show, they gave me the opportunity to visit with Makiko Tada in her studio and while I was there she taught me how to do “Kute-Uchi” hand loop braiding. I have since taken more classes in it, and done more studying. This craft, like finger loop braiding, has the disadvantage that once you start a braid, there is really no way to put the work down until it is finished. Also, if you want to experiment with the multi-person braids you actually need multiple people. That is, unless you have some “helping hands” to hold the loops for you.
I’ve seen several designs for these, but most of them seemed either too primitive or too engineered. Some are made of PVC pipe or other humble materials. Some have magnetic bases to keep them from shifting, but then you need a metal table. anyway, I thought that some wood would be nicer, and friction would probably be enough to keep them from shifting. A few hours in the shop, and here we are!
Helping hands in use, from above
Here you can see the kute-uchi hands in use. This is just a simple 5-loop braid, but I can stop at any time by sliding the loops off my hands onto the dowel ends. The bar in the center keeps the two sides separate, and fiction between the wooden base and the tablecloth keeps tension on the loops. If I need more tension for some reason, I can always put a weight bag on the base to increase the friction. the hands do need to move forward, as uptake from the braid makes the distance between the hands and the fixed point shorter as the braid progresses.
Close-up
Here’s a closer shot from the front. The dowel just goes through the upright post. A set screw keeps the dowel from sliding out. The upright is in a shallow mortise for stability, and a screw comes up from underneath to keep that attached. There’s no glue, so I can remove the screws if I need to take the whole thing apart for travel or something. There’s a bit of sealer on it to stabilize the wood, but no finish to make it slippery.
I actually made three of these. I needed at least two for making two-person braids, and why not make an extra one while I was working? I had three good pieces of dowel in the surplus rack.
I’ve been wanting these for a while, so it is really good to finally get around to making them.
